CoreView File Recovery
If the DVR Express Core loses power during a recording, the file being recorded is "incomplete" and must be repaired in order to access it. As well, if the Core is disconnected from the Control PC during recording and the DVR fills up the SSDs, ...
How to Create a CoreView Backup File
The following outlines the steps necessary to create a CoreView backup file (assumes recordings have been made): 1. Run the “CoreView” software. 2. Click on the “Backup and Restore” button (the 2nd icon that has a film canister on it). ...
Why does deleting recordings not always free up space?
The DVR Express Core file system does not support recording to multiple blocks of free space. De-fragmentation of the file system is not supported as it is time consuming and risks loss of data. The scratch file created prior to recording always uses ...
My GigE Vision camera status shows it as disconnected
Open the “Connect” tab of the camera and check “Enable” in the “Force IP” box. Specify an IP address that uses the same subnet as the IP address of your connected network. The IP address of the connected network will be shown in the ...
I can't find the multicast settings box in the connect tab
Follow the steps here: My camera is connected to a GigE Vision switch, but its status shows it as disconnected If the camera supports multicasting, the multicast settings box will load after pressing "Reconnect/Rescan".